探地雷达测试仪备用电源设计方案
传统野外探地雷达测试仪采用铅酸电池作为移动备用电源,由于铅酸电池自身能量密度低,质量重、倍率放电效率低,非环保等缺点,已经无法满足现代便携式工业仪器设备所需备用电源的需求。由于锂电池组具备高能量比、轻质量、小体积、高循环寿命、高安全、高电压一致性等独特的优点,已经在众多工业仪器设备领域成为替代铅酸电池首选。
探地雷达测试仪具有高工作电压、长时间及特殊环境温度的要求,在锂电池电芯方面采用国际品牌松下锂电芯,用6串8并组合实现客户相关参数需求。在锂电池保护电路保护方面,采用6串比亚迪硬件保护电路,以实现成品锂电池的最大过流25A,持续放电电流8A。
一、 Application circuit
主要电器性能和指标 Topt=25℃
Item 项目 | Symbol 符号 | Contet 详细内容 | Criterion 标准 |
Overcharge Protection 过充电保护 | VDET1 | Overcharge detection voltage 过充电检测电压 | 4.25±0.025V |
tVDET1 | Overcharge detection delay time 过充电检测延时时间 | 0.5S-1.5S | |
VREL1 | Overcharge release voltage 过充电解除电压 | 4.15S±0.025V | |
Overdischarge Protection 过放电保护 | VDET2 | Overdischarge detection voltage 过放电检测电压 | 2.75±0.05V |
tVDET2 | Overdischarge detection delay time 过放电检测延时时间 | 120-150ms | |
VREL2 | Overdischarge release voltage 过放电解除电压 | 3V±0.025V | |
Overcurrent Protection 过电流保护 | VDET3 | Overcurrent detection voltage 过电流检测电压 | 0.2±0.01V |
IDP | Overcurrent protection current 过电流保护电流 | 25±0.5A | |
tVDET3 | Overcurrent detection delay time 过电流检测延时时间 | 9.6mS-14.4mS | |
Release condition 保护解除条件 | Cut load 断开负载 | ||
Short Protection 短路保护 | Detection condition 保护条件 | Exteriorcondition 外部电路短路 | |
TSHORT | Detection delay time 检测延时时间 | 280uS-320uS | |
Release condition 保护解除条件 | Cut short load 断开短路负载 | ||
Interior resistance 内阻 | RDS
| Main loop electrify resistance 主回路通态内阻 | VC=4.2V RDS≤40mΩ |
Current consumption 消耗电流 | IDD | Current consunm in normal operation 工作时电路内部消耗 | 5.0ua Tyoe 10.0uA Max |
Current in operation 正常工作电流 | IDD | ≤15A |
标签:  探地雷达 锂电池案例
- 上一条电动叉车锂电池设计方案
- 下一条没有了